Table of Contents

CNC 6040Z

port pinning

JP-3163B ver. 3.9
Pin 1: Spindle on/off Relay 1(active low)
Pin 2: X Axis Step (active low)
Pin 3: X Axis Dir (active low)
Pin 4: Y Axis Step (active low)
Pin 5: Y Axis Dir (active low)
Pin 6: Z Axis Step (active low)
Pin 7: Z Axis Dir (active low)
Pin 8: A Axis Step (active low)
Pin 9: A Axis Dir (active low)
Pin 10:Estop (active low)
Pin 11: X Axis Limit Switch (active high) = when NC switch(es) open
Pin 12: Y Axis Limit Switch (active high)
Pin 13: Z Axis Limit Switch (active high)
Pin 14: Buffer Chips “Enable” controlled by computer if Jumper 3 is set to 1-2 position
Pin 15: Probe (active low)
Pin 16: Is supposed to turn Relay 2 on/off but is currently not connected in board.
Pin 17: PWM 0-10V for VFD Spindle AN1 (if jumper 4 is in default 1-2 position) active low
Pin 18: Gnd
Pin 19: Gnd
Pin 20: Gnd
Pin 21: Gnd
Pin 22: Gnd
Pin 23: Gnd
Pin 24: Gnd
Pin 25: Gnd or NC

sheme

!!! TODO !!!

DB25M kabel

DB25M na DB25M … kupiti

Stol

Mario: Od profilnih cijevi sa kotačima (da ga je lakše selit i transportirat). Gore lim ili kada uz poklopce sistemom da se skine radi čiščenja i održavanja. U donji dio konstrukcije stola se strpaju police- nešto kao ormar za alat, plus rezervoar za vodu te sauger / ili mali kompresor.

Ivica: optimalne dimenzije cijevi za sto bile bi 30x30x1,5. Stol ne bi smio bit na kotacima dok stroj radi, treba stavit podesive nogice s navojem minimalno M12. vani treba ostavit oko 10mm navoja da se moze spustit na kotace.

Pleksi tacna i poklopac

End-stopovi

end-stop senzori sa svake strane, 6 komada

Komp

linux kompjuter za wifi → linuxcnc/gcode → SXCNC pošalje mu se fajl za samostalno glodanje. Može

Set alata za stezanje

Opremu za stezanje obradaka odmah naručit. Dobar škripac (pazit da nije previsok) i set za stezanje (tipa ovo:

Set alata ostalo

set alata za glodanje potrošnih raznih veličina (ebay)

Bulk materijal

Bulk kvalitetnog aluminija za glodanje npr AlS1Mn 5 mm, 1 m^2

Puhalica zraka i tekućine

Software

Tehničke karateristike

6040 triaxial engraving machine part parameters:
Control box parameters:

Control box iznutra

User manuals