User Tools

Site Tools


project:radiona_stereoscope

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision Both sides next revision
project:radiona_stereoscope [2018/08/23 13:08]
dp [Build instructions]
project:radiona_stereoscope [2018/08/23 13:08]
dp [Build instructions]
Line 29: Line 29:
   - Put on the lenses (''​04''​) – they should be sandwiched between two plastic elements (''​02''​). Note the orientation of the lenses – more convex (more curved) side of the lens should be facing towards the screen.   - Put on the lenses (''​04''​) – they should be sandwiched between two plastic elements (''​02''​). Note the orientation of the lenses – more convex (more curved) side of the lens should be facing towards the screen.
   - Put the rubber bands (''​09''​) to the bottom plastic plate (''​09''​).   - Put the rubber bands (''​09''​) to the bottom plastic plate (''​09''​).
-  - Connect the upper and bottom plate and adjust screen to lens distance. Start with 50 mm distance between the plastic plates. If the image is not sharp while watching trough the lenses, then distance should be adjusted closer of further ​+  - Connect the upper and bottom plate and adjust screen to lens distance. Start with 50 mm distance between the plastic plates. If the image is not sharp while watching trough the lenses, then distance should be adjusted closer of further.
   - Fix the remaining screws ​   - Fix the remaining screws ​
  
project/radiona_stereoscope.txt · Last modified: 2018/10/16 14:46 by dp